Volume : 9, Issue : 6, JUN 2023

NATIONAL CONFERENCE ON INNOVATIONS IN COMPUTING TECHNOLOGIES (NCICT'23)

IMPLEMENTATION OF ELECTRIC VEHICLE CHARGING STATION USING SUSTAINABLE ENERGY

DR.M.YUVARAJU, M.JENITHRAJ, B.NILOPARNISHA, I.POOVARASAN, P.SOWMIYA

Abstract

Today, the world is turning to electric transportation to reduce pollution from non-renewable vehicles and provide an alternative to expensive fossil fuels. But for electric cars, navigation and charging are the two main issues that affect them over conventional cars.

With the introduction of electronic devices, instead of waiting for hours at the charging station, you can now park your car in the car park or in your garage to charge it even while driving an electric vehicle. Increasing pollution and rapid consumption of fossil fuels (petroleum, diesel, etc.) pave the way for electric vehicles to enter the market.

However, charging electric vehicles with conventional energy will eliminate the goal of clean transportation. To benefit from an electric car, it is necessary to pay for the use of electricity from renewable sources such as solar and wind. In this project, the electric car is charged with three types of charging: DC fast charging, AC charging and wireless charging. Smart user authentication based on RFID (Radio Frequency Identity) is also built in.

Article : Download PDF

Cite This Article

-

Article No : 46

Number of Downloads : 743

References

1. Agarwal, K.; Jegadeesan, R.; Guo, Y.X.; Thakor, N.V. Wireless Power Transfer Strategies for Implantable Bioelectronics. IEEE Rev. Biomed. Eng. 2017, 10, 136–161.

2. Wireless Power Consortium. Qi Specification Power Delivery; V1.3.; Wireless Power Consortium: Piscataway, NJ, USA, 2021.

3. Standard IEC 63028:2017; Wireless Power Transfer Airfuel Alliance Resonant Baseline System Specification (BSS). International Organization for Standardization: Geneva, Switzerland, 2017.

4. Raab, F.; Asbeck, P.; Cripps, S.; Kenington, P.; Popovic, Z.; Pothecary, N.; Sevic, J.; Sokal, N. Power amplifiers and transmitters for RF and microwave. IEEE Trans. Microw. Theory Tech. 2002, 50, 814–826.

5. Microsemi, P. Gallium Nitride (GaN) Versus Silicon Carbide (SiC) In the High Frequency (RF) and Power Switching Applications; Digikey:Thief River Falls, MN, USA, 2014.

6. Schuylenbergh, K.; Puers, R. (Eds.) Inductive Powering; Analog Circuits and Signal Processing; Springer: Dordrecht, The Netherlands, 2009.

7. Mai, R.; Liu, Y.; Li, Y.; Yue, P.; Cao, G.; He, Z. An Active-Rectifier-Based Maximum Efficiency Tracking Method Using an Additional Measurement Coil for Wireless Power Transfer. IEEE Trans. Power Electron. 2018, 33, 716–728.

8. Cochran, S.; Costinett, D. Frequency Synchronization and Control for a 6.78 MHz WPT Active Rectifier. In Proceedings of the 2018 IEEE 19th Workshop on Control and Modeling for Power Electronics (COMPEL), Padua, Italy, 25–28 June 2018; pp. 1–7.

9. Colak, K.; Asa, E.; Bojarski, M.; Czarkowski, D.; Onar, O.C. A Novel Phase-Shift Control of Semibridgeless Active Rectifier for Wireless Power Transfer. IEEE Trans. Power Electron. 2015, 30, 6288–6297.

10. Ahn, D.; Hong, S. A Study on Magnetic Field Repeater in Wireless Power Transfer. IEEE Trans. Ind. Electron. 2013, 60, 360–371.

11. Rindorf, L.; Lading, L.; Breinbjerg, O. Resonantly coupled antennas for passive sensors. In Proceedings of the 2008 IEEE Sensors, Lecce, Italy, 26–29 October 2008; pp. 1611–1614.

12. Baker, M.W.; Sarpeshkar, R. Feedback Analysis and Design of RF Power Links for Low-Power Bionic Systems. IEEE Trans. Biomed. Circuits Syst. 2007, 1, 28–38.